Specifications CFW10

Power Supply

Voltage

Single phase

110-127 Vac (+10%, -15%)

Single phase

200-240 Vac (+10%, -15%)

Frequency

50 / 60Hz +/- 2Hz

Displacement Power Factor (Cos)

Greater than 0.98

Enclosure

Degree of Protection

IP20

Control

Control Mode

Linear or Quadratic V/Hz

Power Output

IGBT Transistors

Sinusoidal PWM (Space Vector Modulation)

Switching Frequency

2.5, 5, 10 or 15kHz

Frequency Range

0-300 Hz

Overload Capacity

150% for 60 seconds, repeatable every 10 min.

Control Inputs

4 programmable isolated digital inputs

1 programmable differential analog input: 0-10V, 0-20mA or 4-20mA

Control Outputs

1 programmable relay output: Form C contacts rated 250V / 0.5A

Safety

Protections

Motor over current

DC link over voltage

Motor overload

DC link under voltage

Output phase-to-phase short circuit

Drive over temperature

Output phase-to-ground short circuit

External fault

Programming error

Ambient

Temperature

32°F (0°C), up to 122°F (50°C) without output current derating

Humidity

5-90% Non Condensing

Altitude

0-3300 ft (1000m), up to 13,200 ft (4000m)

with 1% / 330ft (100m) output current derating

Regulatory Conformance

EMC Directive 89 / 336 / EEC

Electromagnetic compatibility, Industrial Environment EMC Emission and Immunity

ENC61800-3 for the FA version - optional

LVD 73/23/EEC

Low Voltage Directive

UL 508 C

Power Conversion Equipment

Special Functions

Linear and “S” ramp accel and decel, local/remote control, FWD/REV selection, DC braking, manual and auto torque boost, mo- tor slip compensation, electronic pot, two skip frequencies, maximum and minimum adjustable frequency limits, adjustable out- put current limit, 8 present speeds and JOG, PID Controller

Keypad

3 digit display, 2 indication LEDs and 4 keys

Readouts for: output freqency (Hz), output current (A), output voltage (V), value proportional to frequency (Ex: RPM), heatsink temperature, fault and status messages.

Mounting

Surface mounting with screws